Before opening a glove-style hand mask, check how to take it out, how long to wear it, and what to do after removing it. If you try to read the package after covering both hands, you will have to open it again while trying to make out the fine print. Rather than memorizing the time alone, check where to insert your hands, when to remove the gloves, and what to do with the remaining liquid so you are less likely to get stuck partway through.
This guide covers single-use gloves soaked in serum. They require different preparation from reusable cloth gloves worn over cream. Some are joined together, some come separately, and some have tabs to fasten the cuffs. Compare the shape of the gloves you have with the package instructions as you go.
1. Read the opening instructions and wear time before opening the pouch

Start with the directions for use on the back of the pouch. Check in order whether to separate the gloves, how to open the wrist ends, how many minutes to leave them on, and what to do after removing them. The separation line and the opening for your hand may be close together. If there is a diagram, check separately how to separate the gloves and how to open each cuff.
If the gloves are already separate, there is no need to cut the ends. If they are joined, look at the shape of the gloves and use only the marked cut line. The tear point on the pouch and the cut line on the gloves may be marked separately. If you cannot find the hand opening, match the glove to the picture on the pouch and try turning it before cutting further into the finger end or edges.
After washing your hands, check the package for any instructions about the condition of your hands before use. Keep a towel for drying your hands and a tray for the used masks nearby so you do not need to open cabinets or drawers once the gloves are on. If you are timing the application, set the timer in advance so you can start it as soon as you put the gloves on. A touchscreen may not respond through thick gloves.
2. Open the cuff and slide your fingers all the way in

Spread out the mask and distinguish the finger end from the wrist end, which opens straight across. Insert your fingers through the cuff, line up your thumb first, and then guide the other fingers into place. If a finger catches, back out slightly and check the thumb position and any fold inside before trying again. If the masks come out folded together, open them one at a time to find the cuffs more easily.
If the inner sheet and outer film are separate, open the cuff slightly and identify which surface should touch your hand. If you slip your fingers between the film and the sheet, the glove may look like it is on correctly even though the serum-soaked lining is not touching your hand. If you cannot see all the way into the glove, look at the two edges at the wrist and reinsert your fingertips inside the lining.

If there is a fastening tab, get your fingers in place first, then fasten the wrist as directed. If you fasten it first, it can be harder to widen the cuff to correct the direction of your fingers. If the product has no tab, choose a spot where you can rest your hands without bending your wrists before adding tape. If the second glove is hard to open once the first is on, open and lay out both cuffs in advance next time.
3. Rest your hands and wait for the time on the label

With both gloves on, rest your hands and start tracking the time from when you put them on. Knowing when to take them off gives you a clear stopping point if you are watching a video or reading. Follow the time stated for your product. There is no need to use the same timing as a different mask you used before or to extend the time simply because the gloves still feel damp.
If the fingertips are loose, ease the cuff open and realign your thumb and fingers instead of clenching them tightly inside the gloves. If the instructions say to spread the liquid toward the wrists, check whether to redistribute it with the masks on or spread it by hand after removing them. If liquid leaks from the cuff, inspect the opening over the tray you prepared so you can see what needs wiping without going to fetch a cloth or paper.
If anything feels wrong during use, take the masks off even if the specified time has not elapsed and follow the product precautions. If you fall asleep with them on, it is harder to check when to remove them or how your hands are doing. If you use them before bed, start while you can still stay awake long enough to take them off.
4. Hold the cuff to remove each mask

When the time is up, undo any fastening tab first and hold the cuff. Tilt your fingertips slightly downward, position your hands where any drips can be caught, and slide each mask off slowly from wrist to fingertips. Pulling only on the fingertips stretches the mask and makes it harder to see where it still touches your hand. If your fingers are hard to free, widen the cuff a little and remove the gloves one at a time.
After removing the first glove, check where you will set it before removing the other. If you drop it on a surface with the cuff pointing down, liquid left inside may spill. Place it on a tray or similar surface, then deal with the packaging after removing both gloves. If a mask is labeled single-use, do not put it back in the pouch to use again, even if it is still damp.
5. Check whether to work in or rinse off the remaining liquid

If the directions say to work in the remaining liquid, spread what is already on your hands in a thin layer over the bases of your fingers and toward your wrists as well as over the backs of your hands. Look at the fingertips, where liquid can collect, and move some to any area you have not covered. Clear liquid is hard to see; light from an angle makes it easier to spot where a thicker layer remains.

Bring your hands together and spread your fingers slightly to see the area where the backs of the hands meet the fingers. If liquid has gathered between your fingers, check whether you can spread it toward the backs of your hands or your wrists before adding more. It is easy to miss the bases of the fingers when sweeping over the backs of the hands. Follow your product's instructions for how far to spread the liquid beyond the wrist.
If the instructions say to wipe or rinse off the liquid, do that first. If you are unsure whether to apply cream afterward, read the mask's after-use instructions before deciding. If you want to review how much cream to use or the order in which to spread it, see how to apply hand cream.
Next time, prepare for the step that slowed you down. If you could not find the opening, look at the package diagram before washing your hands. If you lost track of time, set the timer first. If you had nowhere to set the used gloves, keep a tray nearby. When you change products, read the wear time and after-use instructions again even if the steps are otherwise the same.